**The most used, most needed and most valuable Compressed Air Formulas**

Do you have access to the most used, most needed and most valuable Compressed Air Formulas? Here’s one of the most used formulas you should keep on hand…

How to find how many CFM your air compressor delivers.

**Follow these steps to find out how many
CFM Your Air Compressor actually delivers**

1. **STOP** the compressor unit

2. **CLOSE** the outlet valve on the tank/air receiver

3. **DRAIN** the condensate from air receiver until there is 0 PSIG -then **close the drain valve **

4. **NOTE THE TIME**– in minutes & seconds (Best to write it down.) Then START THE UNIT.

When the compressor unit stops and unloads – then NOTE THE TIME again – in minutes & seconds. Convert the minutes into seconds and then total the number of seconds it takes between START and STOP/UNLOAD.

5. NOTE the **GUAGE PSIG** reading

6. NOTE the Air Receiver/Tank **GALLON SIZE **

7. **USE THIS FORMULA:**

**TANK GALLONS x .536* x PSIG divided by SECONDS **

**.536 is a formula factor for the unknown that works to give you the CFM delivery.*

**EXAMPLE:**

You have an **80** gallon tank, your total start to stop/unload time was 3 minutes and 9 seconds.

Change the minutes to seconds timed (60 x 3= 180 seconds plus 9 seconds totals 189). You will use the total number of seconds**189** and the noted **175** PSIG within the formula as shown below:

**80** multiplied by **.536** = 42.88

42.88 multiplied by **175** (example PSIG) = 7504.00

7504.00 divided by **189** (total seconds**)**= **39.70 CFM delivered**

You now know that your air compressor is delivering 39.70 CFM

*Your Response to this evaluation should be to compare this number with what your air compressor manufacturer says your CFM should be and evaluate how efficiently your compressor is running.*

**Compressor Terms you should know:**

**Cubic Feet Per Minute (cfm)** – Volumetric air flow rate.

**“psig” **means pounds per square inch, GAGE pressure. Gage pressure is the absolute pressure of something, with the atmospheric pressure subtracted. In practice, when someone gives a pressure in just “psi” they probably mean gage pressure. If they mean absolute, they should be using “psia.”

**Gauge Pressure** – The pressure determined by most instruments and gauges, usually expressed in psig. Barometric pressure must be considered to obtain true or absolute pressure

**Load Time** – Time period from when a compressor loads until it unloads.

**Unload **– (No load) Compressor operation in which no air is delivered due to the intake being closed or modified not to allow inlet air to be trapped.

**Receiver** – A vessel or tank used for storage of gas under pressure. In a large compressed air system there may be primary and secondary receivers.

**Demand** – Flow of air at specific conditions required at a point or by the overall facility.

Tommy McGuire

McGuire Air Compressors, Inc.

*“Real People with Real Compressor Experience”*

**1-888-229-9999**

**www.industrialaircompressors.biz**

**www.hosereels.biz**

**www.airdryers.biz**